 |
 |
Processor Lifts
Contents:
Product Summary:
The JOBO Lift Accessory is an item you can add to your CPE-2 Plus (Lift #4062), CPA-2, or CPP-2 processors (Lift #4072 for either). It allows you to dump and fill the chemicals easier than doing it by hand. Also, when you use the Lift, the chemicals are introduced to the film in a more consistent manner which will help your processing run-to-run.
Key Features
Makes life a little easier
The Lift accessory makes it easier to dump and fill the chemical and rinse steps. Instead of grabbing the tank off the processor, removing the tank cap, pouring out the solution, pouring in the next solution, replacing the tank cap, and putting the tank back on the processor, all you do is pull back on handle to drain the tank, then lower the handle and fill the tank.
"Better" processing
"Better" because processing with or without the Lift is pretty darn good. You will get more consistency with the Lift, so we can call that part "better".
Send mail to info@omegasatter.com with questions or comments about this web site. Copyright © 1997-2005 JOBO Fototechnic, Inc. All rights reserved. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders. Copyright to all of the photographs displayed on this site is owned by each of the photographers. You may not sell, publish, license or otherwise distribute any photographs without the written permission of the photographer.
This page last updated on 06/04/04