 |
 |
Instructions for the
PrintLab 3503R
12. Operation
The PrintLab 3503R accomplishes the complete cycle of development, fixing, rinsing and drying of the materials, automatically. The process parameters can be individually changed for different types of paper and processes. On starting the machine, the unit goes into the ‘Stand-By’ phase after accomplishing a self-check and reaching the working temperature. This means that the set temperature of the working solutions is maintained. The machine has an automatic replenishment system. Five infrared sensors register the width of the inserted paper without touching it, the machine is started (the transport rollers start turning, the dryer is activated) and after processing a surface area of 0.25 m2, a replenishment cycle is started. The replenisher rate per m2 (square meter) is adjustable.Inserting photo paper
Open the lid of the paper-loading area. Put the paper, emulsion side up, on the paper-loading tray. Use the left or right wall of the tray as a guide to ensure that the paper is put in parallel position to the transport rollers. Push it slowly forward (the machine starts working) until the rollers start transporting the paper. As soon as you have closed the lid of the paper-loading area, you can turn on the light. As long as the display --- blinks, do not feed any additional prints so that paper overlap is prevented.Safety devices
When opening the cover of the unit, a safety switch turns off the drive.All heating elements are fitted with a safety temperature cut out switch, which is activated in case the components overheat, and is re-set automatically after cooling.
Operation
Open water tap before starting the unit!Close water tap after turning off the unit!
The unit incorporates a microprocessor that holds the memory of the programs for the development of different photographic materials and chemicals. All programs (as well as any modifications) are maintained after turning off the unit.
If you have any questions, contact us utilizing one of the following methods:
Equipment or Processing Questions:
- Phone: Customer Service Department (734) 205-9421
e-mail: tech@jobo-usa.comRepair Questions:
- Phone: Repair Department (734) 205-9420
- e-mail: repair@jobo-usa.com
JOBO Contacts
- Telephone (734) 677-6989
- Fax: (734) 677-6963
- Postal address
- P.O. Box 3721, Ann Arbor, MI 48106
- Shipping Address
- 4401 Varsity Drive, Suite D, Ann Arbor, MI 48108
- Electronic mail
- Sales: sales@jobo-usa.com
- Equipment & Processing Questions: tech@jobo-usa.com
Repair Information: repair@jobo-usa.com- Shipping or Billing Questions: help@jobo-usa.com
Webmaster: webmaster@jobo-usa.com
Back to Top
Send mail to webmaster@jobo-usa.com with questions or comments about this web site. Copyright © 1997-2005 JOBO Fototechnic, Inc. All rights reserved. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders. Copyright to all of the photographs displayed on this site is owned by each of the photographers. You may not sell, publish, license or otherwise distribute any photographs without the written permission of the photographer.
This page last updated on 03/20/02