 |
 |
Instructions for the
PrintLab 3503
14. Care And Maintenance
Daily cleaning
1. Clean paper-loading tray with cloth. Never rinse, water can damage the electronics!
2. Clean angled paper guide mounted at rack 2 with a cloth.
3. Check filling level of reclamation containers and cubitainers. Fill processor tanks up to overflow.
4. To reduce formation of condensation, leave the light-trap lid over the paper-loading tray open.
Weekly replenishment
1/3rd of the contents of tanks (1 and 2) should be replenished by replenisher at least once a week. Should this not be reached, replace about two liters of used solution with fresh working solution in both tanks. If the unit is not continuously used, please contact your supplier of chemicals. They can offer you several additives, protecting the chemicals from oxidation.
Every two weeks
1. Clean housing parts with a wet cloth.
2. Remove and rinse racks with running fresh water.
3. Clean filters of CD and BX and reinsert them.
Note: Do not use any cleaning agents which contain solvents or chlorine, as these will cause embrittlement and/or destroy the machine. We recommend Processor Clean II to remove soiling from inside the tanks and the hosing.
Cleaning every 3-4 months or when changing the process
1. Drain the chemicals from all containers and tanks.
2. Clean containers and tanks with Processor Clean II (dissolve Processor Clean II completely in hot water before using it).
3. Drain containers and tanks of cleaning solution.
4. Rinse containers and tanks with water
5. Drain water from container and tanks
Note: Cleaning with fresh water after the use of processor Clean II, should be done twice at least twice. After filling the processor with new solutions, it is advisable to run a test strip for densitometric control.
Maintenance every 12 months
Lubricate worm gears with appropriate grease.
If you have any questions, contact us utilizing one of the following methods:
Equipment or Processing Questions:
- Phone: Customer Service Department (734) 205-9421
e-mail: tech@jobo-usa.comRepair Questions:
- Phone: Repair Department (734) 205-9420
- e-mail: repair@jobo-usa.com
JOBO Contacts
- Telephone (734) 677-6989
- Fax: (734) 677-6963
- Postal address
- P.O. Box 3721, Ann Arbor, MI 48106
- Shipping Address
- 4401 Varsity Drive, Suite D, Ann Arbor, MI 48108
- Electronic mail
- Sales: sales@jobo-usa.com
- Equipment & Processing Questions: tech@jobo-usa.com
Repair Information: repair@jobo-usa.com- Shipping or Billing Questions: help@jobo-usa.com
Webmaster: webmaster@jobo-usa.com
Back to Top
Send mail to webmaster@jobo-usa.com with questions or comments about this web site. Copyright © 1997-2005 JOBO Fototechnic, Inc. All rights reserved. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders. Copyright to all of the photographs displayed on this site is owned by each of the photographers. You may not sell, publish, license or otherwise distribute any photographs without the written permission of the photographer.
This page last updated on 03/20/02