 |
 |
Instructions for the
PrintLab 3503
12. Operation
The processor accomplishes the complete cycle of development and fixing of the material automatically. The process parameters can individually be changed to the different types of paper and processes. On starting the machine, the unit goes over into the ‘Stand- By’ phase after accomplishing a self-check and reaching the working temperature.
This means that the Solution temperature of the working solutions is maintained.
Feed in of photo paper
Open the lid of the feed-in area. Put the paper, emulsion side up, on the feed-in tray. Use the left wall of the tray as a guide to ensure that the paper is put in parallel to the transport rollers. Push it slowly forward (the machine starts working) until the rollers start transporting the paper As soon as you have closed the lid of the feed-in area, you can turn on the light. Do not feed in paper too quickly, one after the other, to avoid paper overlap. The transport motor switches off approximately 20 seconds after the paper has come out. A beep indicates when the feed-in area is free for inserting the next print.
Due to the normal processing of photo paper, BX becomes contaminated by CD. The liquid level of tank 1 drops and has to be filled up with replenisher or fresh developer from time to time.
Safety devices
When opening the cover of the unit, a safety switch turns off the drive. All heating elements are fitted with a safety temperature switch, which is activated in case the components overheat and is turned on again automatically after cooling.
Note: When processing several sheets at one time, always make sure that the last print is inserted at the left side, otherwise not all prints may exit the processor.
If you have any questions, contact us utilizing one of the following methods:
Equipment or Processing Questions:
- Phone: Customer Service Department (734) 205-9421
e-mail: tech@jobo-usa.comRepair Questions:
- Phone: Repair Department (734) 205-9420
- e-mail: repair@jobo-usa.com
JOBO Contacts
- Telephone (734) 677-6989
- Fax: (734) 677-6963
- Postal address
- P.O. Box 3721, Ann Arbor, MI 48106
- Shipping Address
- 4401 Varsity Drive, Suite D, Ann Arbor, MI 48108
- Electronic mail
- Sales: sales@jobo-usa.com
- Equipment & Processing Questions: tech@jobo-usa.com
Repair Information: repair@jobo-usa.com- Shipping or Billing Questions: help@jobo-usa.com
Webmaster: webmaster@jobo-usa.com
Back to Top
Send mail to webmaster@jobo-usa.com with questions or comments about this web site. Copyright © 1997-2005 JOBO Fototechnic, Inc. All rights reserved. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders. Copyright to all of the photographs displayed on this site is owned by each of the photographers. You may not sell, publish, license or otherwise distribute any photographs without the written permission of the photographer.
This page last updated on 03/20/02