 |
 |
PRINTLAB
3502
INSTRUCTION
MANUAL
Copyright © 2001 by JOBO Fototechnic, Inc. All rights reserved. No portion of this book may be reproduced in any form without express written consent from JOBO Fototechnic, Inc.
Use Two
Persons
To Lift!
62 lbs. / 28 kg
Weight!
4. Preparation For Installation
Do NOT switch on the unit without filling the tanks as this can cause SERIOUS DAMAGE to the processor.
1. Carefully remove all packing materials from racks and tanks.
2. Set unit up according to installation instructions on following pages.
3. Adapt hoses to available supply and drain lines.
4. Run test of developer (CD) and bleach/fix (BX) baths.
5. Drain water, fill with chemicals and begin processing.
If you have any questions, contact us utilizing one of the following methods:
Equipment or Processing Questions:
- Phone: Customer Service Department (734) 205-9421
e-mail: tech@jobo-usa.comRepair Questions:
- Phone: Repair Department (734) 205-9420
- e-mail: repair@jobo-usa.com
JOBO Contacts
- Telephone (734) 677-6989
- Fax: (734) 677-6963
- Postal address
- P.O. Box 3721, Ann Arbor, MI 48106
- Shipping Address
- 4401 Varsity Drive, Suite D, Ann Arbor, MI 48108
- Electronic mail
- Sales: sales@jobo-usa.com
- Equipment & Processing Questions: tech@jobo-usa.com
Repair Information: repair@jobo-usa.com- Shipping or Billing Questions: help@jobo-usa.com
Webmaster: webmaster@jobo-usa.com
Back to Top
Send mail to webmaster@jobo-usa.com with questions or comments about this web site. Copyright © 1997-2005 JOBO Fototechnic, Inc. All rights reserved. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders. Copyright to all of the photographs displayed on this site is owned by each of the photographers. You may not sell, publish, license or otherwise distribute any photographs without the written permission of the photographer.
This page last updated on 03/20/02