navcol.gif (19377 bytes)
banner_fybi.gif (12152 bytes)
Support Pagebar
 

Instructions For The JOBO CPE-2 Plus Processor

#4065 (CPE-2 Plus) & #4069 (CPE-2 Plus Starter Kit)

Index Section

[CPE-2 Plus Starter Kit]

Back to Top

How to Use This Manual

Information needed to operate your processor successfully with a wide variety of processes is included in this instruction manual. We urge you to read all the basic information contained in Section One and Section Two. Then read the pages of Section Three that describe the processes you wish to use. If you are having problems with your processor or processing, see the pages of Section Four. For conversions, tables and lists see Section Five.

If you have obtained this instruction manual as a replacement to earlier editions, use the process recommendations in this web page (where they are different), not the recommendations in the earlier manual(s). These instructions reflect the changes that have been made in film, paper, and chemicals since the original book was written. (If you already have processing procedures that completely satisfy you, don't change them just to match the directions in this web page.)

There are three types of special notations or cautionary information in this manual:
Note, Caution, and Warning. The type and format of each is listed below:

Note: Text in this format is informative. It contains additional details to explain the basic information presented.

Caution: Text in this format presents important procedural information. Failure to follow these instructions could adversely affect the processing of your film or paper.

WARNING: Text in this format presents critical information. Possible damage to your equipment or personal injury could result from not following these instructions!

Copyright:

Copyright © 1997 by JOBO Fototechnic, Inc. All rights reserved. No portion of this web page may be reproduced in any form without express written consent from JOBO Fototechnic, Inc.

Every effort was made to include up-to-date and accurate information in this manual. All manufacturers, including JOBO, maintain the right to change specifications for their products. Changes may be made to specifications without notice. For the most current product specifications and usage, contact the manufacturer.

JOBO makes no claim for the accuracy or usability of other manufacturers' information contained in this manual. The processing recommendations included in this manual may not be optimal for every situation. If you require specific results, test all process instructions for suitability.

JOBO is not liable for any damages, direct or consequential, occurring from the use or misuse of information contained in this manual.

Credits:

Author: Damon Dean

JOBO Contributors: Ken Owen, Chris Mishler, Sam Proud, Paul Rowe

Manual part number 66051. Revision 06/97.

[CPE-2 Plus]

Back to Top

Index:

Important Safeguards

Back to Top

Section 1: Introduction
(all are links to additional pages)

Back to Top

Section 2: General Processing Instructions
(all are links to additional pages)

Back to Top

Section 3: Specific Processes
(all are links to additional pages)

Back to Top

Section 4: Troubleshooting
(all are links to additional pages)

Back to Top

Section 5: Appendices
(all are links to additional pages)

Back to Top

Important Safeguards

This checklist details important electrical and safety considerations. Please read and observe all the following.

Although your processor is designed to work in a wet environment, it is not designed to be totally immersed in water. Any electrical equipment placed close to water may be dangerous, if improperly used. At a minimum, observe these instructions. Contact JOBO to clarify any safety concerns not addressed in this manual, or any you do not fully understand. (See Section 1, Introduction, on how to Contact JOBO.)

  • Keep these instructions available for reference.
  • Do not use the processor until you read and understand all the warnings contained in this manual.
  • Observe all warnings in this manual.
  • If any precautionary information is not clearly understood, contact JOBO for assistance before proceeding.
  • Do not use the processor if:
    • A grounded power outlet is not used (a ground fault interrupt is strongly recommended)
    • The power cord is frayed or damaged
    • The ground connection of the power cord is damaged
    • Fuses of the wrong rating are substituted for correct ratings (see Appendix)
    • If the processor has been dropped or damaged (have it checked by a qualified service technician).
    • The top cover or hardware is removed.
    • Water or chemicals has gotten inside the motor head.
    • There is not at least five inches (15 cm) of water in the lower trough.
  • Use an extension power cord only if required. Be sure the cord is undamaged, grounded and rated at least 500 Watts at 120 Volts.
  • Route all power cords to avoid contact with water. Position cords to prevent stretching or pinching. Avoid placing cords where they could be tripped on, stepped on, or accidentally unplugged.
  • Avoid splashing or spilling of water or chemicals on the motor head of the processor or power cord connections.
  • Do not leave the processor running unattended for overnight or longer.
  • Unplug the processor if it is not being used.
  • Do not attempt to modify or remove any part or function of the processor.

Back to Top

If you have any questions, contact us utilizing one of the following methods:

Equipment or Processing Questions:

Phone: Customer Service Department (734) 205-9421
e-mail: tech@jobo-usa.com

Repair Questions:

Phone: Repair Department (734) 205-9420
e-mail: repair@jobo-usa.com

JOBO Contacts

Telephone (734) 677-6989
Fax: (734) 677-6963
 
Postal address
P.O. Box 3721, Ann Arbor, MI 48106
Shipping Address
4401 Varsity Drive, Suite D, Ann Arbor, MI 48108
Electronic mail
Sales: sales@jobo-usa.com
Equipment & Processing Questions:  tech@jobo-usa.com
Repair Information: repair@jobo-usa.com
Shipping or Billing Questions: help@jobo-usa.com
Webmaster: webmaster@jobo-usa.com
 

Back to Top

jobo_logo_web.jpg (5206 bytes)

Send mail to webmaster@jobo-usa.com with questions or comments about this web site. Copyright © 1997-2005 JOBO Fototechnic, Inc. All rights reserved. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders. Copyright to all of the photographs displayed on this site is owned by each of the photographers. You may not sell, publish, license or otherwise distribute any photographs without the written permission of the photographer.

 

This page last updated on 03/01/05