navcol.gif (19377 bytes)
banner_fybi.gif (12152 bytes)
Support Pagebar
 

Instructions for the

AutoLab ATL-500 #4235
and the
AutoLab ATL 800 #4237

1. WARNINGS FOR YOUR SAFETY

ATL-800.jpg (14369 bytes) ATL-500.jpg (10734 bytes)

ATL-800

ATL-500

 

WARNINGS FOR YOUR SAFETY

  1. The unit should only be used at the voltage indicated on the specification plate at the side of the unit, right under the socket for the electrical power.
  2. Use only a grounded, proper socket, with GFCI protection. Never touch the main power switch with wet fingers.
  3. Before you ever open the unit, disconnect the electrical cord from the Mains.
  4. Only an authorized person should service the unit.
  5. Make sure, that no moisture can enter the air vents at the top of the unit.
  6. Never place the appliance in a sink where draining water can rise up and damage the unit.
  7. Never transport or move the unit while it is filled with water. (See Section 12)
  8. Strong motors drive this unit, therefore never reach into the running unit with your hands.
  9. The unit is equipped with a battery back up which automatically operates, when electric power fails. The processor can only be stopped by using the reset mode ("Up Arrow"+"Down Arrow"+F1).
  10. When switching off the appliance, the lift arm moves into the position, where it empties the water jacket and only 5 minutes afterwards comes back to its rest position to switch off the unit completely.
  11. The processor is built only for use with standard photographic chemicals.
  12. To protect your eyes, skin and respiratory tract we recommend you take appropriate safety measures when handling chemicals. Follow the warning instructions of the chemical manufacturers.
  13. The processor transfers water and liquid chemicals, therefore it is always necessary to operate it with a tank connected.

 

Back to Top

Go to Chapter 2

If you have any questions, contact us utilizing one of the following methods:

Equipment or Processing Questions:

Phone: Customer Service Department (734) 205-9421
e-mail: tech@jobo-usa.com

Repair Questions:

Phone: Repair Department (734) 205-9420
e-mail: repair@jobo-usa.com

JOBO Contacts

Telephone (734) 677-6989
Fax: (734) 677-6963
 
Postal address
P.O. Box 3721, Ann Arbor, MI 48106
Shipping Address
4401 Varsity Drive, Suite D, Ann Arbor, MI 48108
Electronic mail
Sales: sales@jobo-usa.com
Equipment & Processing Questions:  tech@jobo-usa.com
Repair Information: repair@jobo-usa.com
Shipping or Billing Questions: help@jobo-usa.com
Webmaster: webmaster@jobo-usa.com
 

Back to Top

jobo_logo_web.jpg (5206 bytes)

Send mail to webmaster@jobo-usa.com with questions or comments about this web site. Copyright © 1997-2005 JOBO Fototechnic, Inc. All rights reserved. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders. Copyright to all of the photographs displayed on this site is owned by each of the photographers. You may not sell, publish, license or otherwise distribute any photographs without the written permission of the photographer.

 

This page last updated on 03/20/02