 |
 |
Instructions for the
AutoLab ATL-1000 #4210
and the
AutoLab ATL 1500 #422811. Service
Note: All instructions apply to both the ATL-1000 and ATL-1500, except where specifically noted. Only process programming differs between the two versions of the AutoLab processor.
Index
11. Service
11.1 Overload reset
11.1 Overload reset
The AutoLab ATL-1500 does not contain any replaceable fuses. In case of overload an internal circuit breaker will automatically switch off power to the unit. To reset the circuit breaker switch the ATL-1500 off with ON/OFF switch (#10) and wait a few minutes. The unit can then be switched back on. If the ATL-1500 continues to blow the circuit breaker, unplug the unit and contact JOBO service.
If you have any questions, contact us utilizing one of the following methods:
Equipment or Processing Questions:
- Phone: Customer Service Department (734) 205-9421
e-mail: tech@jobo-usa.comRepair Questions:
- Phone: Repair Department (734) 205-9420
- e-mail: repair@jobo-usa.com
JOBO Contacts
- Telephone (734) 677-6989
- Fax: (734) 677-6963
- Postal address
- P.O. Box 3721, Ann Arbor, MI 48106
- Shipping Address
- 4401 Varsity Drive, Suite D, Ann Arbor, MI 48108
- Electronic mail
- Sales: sales@jobo-usa.com
- Equipment & Processing Questions: tech@jobo-usa.com
Repair Information: repair@jobo-usa.com- Shipping or Billing Questions: help@jobo-usa.com
Webmaster: webmaster@jobo-usa.com
Back to Top
Send mail to webmaster@jobo-usa.com with questions or comments about this web site. Copyright © 1997-2005 JOBO Fototechnic, Inc. All rights reserved. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders. Copyright to all of the photographs displayed on this site is owned by each of the photographers. You may not sell, publish, license or otherwise distribute any photographs without the written permission of the photographer.
This page last updated on 03/20/02